HNAS Configuration Requirements
1. The SSC Utility must be copied to a location on the Data Collector server. Note this location, as it is required when you configure a Storage Viewer HNAS Data Collector policy.
2. The Data Collector uses the SiliconServer Control (SSC) CLI to access the Hitachi NAS CLI via Admin EVS (a public network). Therefore, a server administration IP address must be assigned to at least one of the Gigabit Ethernet (GE) interfaces. Refer to the “IP Network Setup” section of the HNAS System Administration Guide.
3. SSC Access must be enabled via the SSC Admin utility on the Hitachi NAS server:
Configuring SSC Access
In the SSC Admin utility, enable SSC Access. The default port number is 206. You also can use this configuration to restrict access to only certain users.
